ATTN: austrian type-R

[speedy108]

I was just curious on what kind of setup you have in your car right now and how much power your putting out.

If you could please give me a run down on your engine mods like: Pistons, Rods, Sleeves, Headwork, turbo system.....ect....

I was thinking of going turbo next year and I don't know if I want to sleeve the block or just weld a block gaurd in. Is 350-375 HP
capable on stock sleeves with pistons, rods,and a blockgaurd?

Please give opinions and suggestions on a setup to make this much HP.

Thanks. Michael

[speedy108]

Oh, and I'll also be using a Hondata stage 2b w/ RC 550cc Injectors.

[austrian type-R]

SETUP:
DRAG III turbo kit
Turbo is water cooled
Haltech e6k ECU
Eagle rods
JE pro series pistons 9:1
Crower valve springs & retainers
AEM fpr
Skunk2 cam gears
Walbro fuel pump (from JRSC kit)
RC 720cc injectors
Clutchnet stage 2
3" Thermal RD exhaust
3" Carsound Cat
3" midpipe resonator
17row oil cooler
JR thermostat
5 Greddy gauges
Apexi AVC-R
Greddy profec B
Tial wastegate 35mm

Comming soon:
DSS axles stage 3


making about 370whp with 1.5 Bar of boost. But this was with maxed out 440cc injecotors and 95 RON fuel. With the 720cc and high octane fuel, there is for sure some more potential. I live in high elevation, so take care of the dyno-numbers. In the USA the numbers are normaly a bit higher than here in the mountains.



1 Kilowatt is 1.36hp